elevations, massage, and timer. Programming the Remote Control: Sync Remote Control with the Base: • To sync the remote with the base, simultaneously hold the Red button on the Control Box and any button on the remote Control (except for TV/PC, LOUNGE, FLAT, ZERO G) for 5 seconds to turn it on. This will allow the remote to pair with the base.
FAQ How do you use timer on remote control no instructions included in box?
What should I do if my Remote controls are not working?
NOTE: Do not press the button on the remote, use the cursor/pointer to press from on the screen. If the buttons do not perform the expected function, continue to another remote type, select Remote Type 2 and used the cursor to test the functions again. One of the remote types should control your external device correctly.
How do I program the remote control to the TV?
Press and hold the program button on the remote control until the LED on the front of the remote control turns on. 2. Press and release the remote control button you wish to use. 3. Press any remote control button except the button that was just programmed. 4a.
How do I enable timer-to-close and Myq smartphone control?
• MyQ Remote LED Light must be installed to enable use of Timer-to-Close or MyQ Smartphone Control of the door. Plug in the MyQ Remote LED Light and make sure it is programmed to the garage door opener. It may take up to 5 minutes to enable Timer-to-Close and MyQ Smartphone Control.
How do I set the self timer on my RC-6 camera?
The camera must be in the Self-timer/Remote Control mode for the RC-6 to~operate. Some cameras have more than one self-timer mode – you must use a mode with the symbol of a remote control unit (above). Pressing the shutter button in this mode gives you a 2 or 10-second self timer delay.